White trainers have a short honeymoon. A week of pavements, one wet commute and the toes are grey, the sole has a black scuff down the side and the laces have gone the colour of weak tea. Most of it comes off with things you've already got under the sink.
The catch is the drying. A lot of the yellow marks people blame on dirt actually appear afterwards, on the radiator. So we'll cover that properly too.
What you'll need
- A soft brush or an old toothbrush
- A bowl of warm water with a few drops of washing-up liquid
- A microfibre cloth
- Bicarbonate of soda
- A melamine sponge (the white "magic eraser" type)
- A mesh laundry bag for the laces
- Kitchen roll or plain white paper for stuffing
Skip the bleach. It seems like the obvious choice for anything white, but it attacks the glue and rubber and often leaves leather and synthetic uppers with a yellow tinge.
The quick method (works on most white trainers)
- Take out the laces and insoles. You'll clean them separately.
- Knock off the loose dirt. Bang the soles together outside and dry-brush the uppers. Dried mud comes off far more easily before you add water.
- Scrub the uppers. Dip the brush in the soapy water and work in small circles. Keep it damp, not dripping.
- Do the sidewalls. A slightly damp melamine sponge shifts most scuffs on the rubber in a minute or two. For stubborn marks, mix bicarb with a little water into a paste and scrub that in.
- Wipe everything down. Go over the whole shoe with a clean damp cloth. Leftover soap attracts dirt and can dry yellow.
- Stuff and air-dry. Paper inside, room temperature, away from heat. More on that below, because it matters.
Leather trainers
White leather is the easiest to bring back. Most dirt sits on the surface, so soapy water and a cloth do the job. A melamine sponge works too, but go gently: it's mildly abrasive. Once they're dry, a thin layer of neutral leather cream keeps the leather supple and makes the next clean easier. Our guide on how to clean and polish leather shoes goes into more detail.
Canvas trainers and white Converse
Canvas soaks dirt into the weave, which is why white Converse go grey so quickly. A bicarb paste is your friend here:
- Brush on a thin layer of paste.
- Leave it for about 15 minutes.
- Scrub it off with a damp toothbrush and wipe clean.
For the rubber toe cap and the stripe round the sole, use the melamine sponge. Most canvas trainers can also go in the washing machine at 30°C inside a pillowcase, which is handy if they're grubby all over. Our guide on how to wash trainers covers the machine method step by step.
Mesh running shoes
Mesh is open and delicate. Use a soft brush and very little water, because anything you put on top runs straight through to the insole. A toothbrush gets into the weave better than a cloth.
White suede or nubuck
No water, no soap. Use a suede brush and a suede eraser instead. The full method is in how to clean suede shoes.
Yellowed soles
Grey and black scuffs come off. Yellowing usually doesn't, at least not with scrubbing. When an older white sole turns yellow, it's the rubber itself that has discoloured over time with light and air. There are sole-whitening products for this, and results vary. Always test on a small patch first, and don't expect miracles on a pair that's been yellow for years.
You can slow it down, though: keep white trainers off sunny windowsills and never dry them on a radiator.
Getting laces white again
- Soak them for half an hour in warm water with washing-up liquid or a spoonful of bicarb.
- Rub them between your hands or give them a scrub with a toothbrush.
- Or pop them in a mesh bag and put them through a white wash.
- Dry them flat. If they're beyond saving, new white laces cost a couple of quid and make a huge difference.
Drying without yellow marks
This is where a lot of white trainers go wrong. Dry them on a radiator or in direct sun, and the moisture moves outwards, dragging dirt and soap residue from inside the shoe to the surface. Where it dries, you get a yellow tide mark. Heat also weakens the glue holding the sole on.
Don't:
- ❌ Put them on or against the radiator
- ❌ Put them in the tumble dryer
- ❌ Leave them in direct sunlight
- ❌ Blast them with a hot hairdryer
Do:
- ✅ Stuff them with plain white paper and swap it out after a couple of hours
- ✅ Leave them at room temperature with air around them
- ✅ Dry the insoles separately
- ✅ Wait until the toe and insole are fully dry before you wear them
Left to air-dry, that usually takes a full day. Until the inside is dry, they'll start to smell musty. How to dry wet shoes explains why.
Drying them faster with a shoe dryer
A shoe dryer works from the inside, where the moisture actually is. Because the shoe dries from within rather than outwards, there's less chance of a tide mark. The Shoefresh Opod (€129) has a LEATHER programme at 40°C for leather trainers and a SPORT programme at 60°C for canvas and running shoes. Its active oxygen tackles the bacteria and fungi behind that musty smell at the same time, so they come out clean and fresh.
If you'd rather have something simpler, the ShoeDry Airo (around €50) is a budget option, although it doesn't have the lower leather setting or automatic start. Whatever you pick, avoid dryers that advertise UV light: the blue LEDs on cheap models do very little, and genuine UV-C isn't something you want in an open device at home. Our complete guide to shoe and boot dryers covers the different types.
Keeping them white for longer
- Protect them from day one. A water and stain repellent spray stops dirt sinking in. See how to waterproof shoes.
- Wipe them after wearing. Fresh dirt comes off with a damp cloth. Dried-on dirt doesn't.
- Save them for dry days where you can. Wet white trainers pick up grime fast.
- Rotate your pairs. Trainers worn every day never fully dry out between wears.
At a glance
| Problem | What to do |
|---|---|
| Grey film on leather | Soapy water, then wipe with a damp cloth |
| Marks in canvas | Bicarb paste, leave 15 minutes, scrub off |
| Scuffs on the sole | Damp melamine sponge |
| Yellowed sole | Sole whitener, test first; keep out of the sun |
| Grubby laces | Soak in soapy water or wash in a mesh bag |
| Yellow marks after drying | Stuff with paper, room temperature, never on the radiator |
FAQs
What's the best way to clean white trainers? Remove the laces and insoles, dry-brush off loose dirt, then scrub the uppers with a soft brush and warm soapy water. Use a damp melamine sponge on the soles, wipe everything with a clean damp cloth and let them air-dry with paper inside.
How do you clean white Converse? Scrub the canvas with a paste of bicarbonate of soda and water, leave it for 15 minutes and brush it off. Clean the rubber toe and sole stripe with a melamine sponge. They can usually go in the washing machine at 30°C in a pillowcase too.
Can you use bleach on white trainers? It's best not to. Bleach can weaken the glue and rubber and often leaves leather and synthetic uppers looking yellow.
How do you clean white soles? A slightly damp melamine sponge removes most scuffs quickly. For stubborn marks, scrub in a bicarb and water paste.
Why do my white trainers go yellow after washing? Usually because they were dried on a radiator or in the sun, or because soap was left in them. Moisture moves to the surface and leaves a yellow line where it dries. Rinse well, stuff them with paper and dry them slowly at room temperature.
Can white trainers go in the washing machine? Canvas ones generally can, at 30°C in a pillowcase. Leather and suede are better cleaned by hand. Check the label inside the tongue first.
A brush, some soapy water and a bit of patience with the drying is usually all it takes. Ready for a fresh start!